Kaco watchDOG Bedienungsanleitung PDF herunterladen

ON ON

1 2

ACT

LNK

APPL

COMM

R22

R21

R20

watchDOG Card Installation

1. Turn off the PV system by setting the

AC/DC switch to the off position.

2. Remove the bottom cover of the inverter.

3. Use the supplied ribbon cable to connect

the watchDOG to the connection terminal

on the left side of the card.

4. Install the card in the left upper corner

as shown. The two upper holes of the

watchdog should snap into the upper

nylon standoffs.

5. Using the two screws supplied with the

watchDOG card, secure the

card to the two standoffs through the

bottom two holes.

6. Move either of the two dip switches into

the ON position if a single inverter is

connected. If multiple inverters are used

please make sure ONLY the last inverter

(furthest from the watchDOG) has one

switch in the ON position.*

*(Refer to Section 5.7 in the Inverter installation manual for the RS485 addressing &

wiring between inverters)

KACO watchDOG quick start

CAUTION!

HAZARDOUS VOLTAGE

Before opening disconnect the

PV generator and the grid.

Note the order of the electrical connection.

1. Disconnect and verify AC and DC

wiring is not energized

2. GND

3. N

4. L1 and L2

5. Interfaces

6. Return

7. Hot

Disconnect in reverse order

ON ON

1 2

CAUTION! 1
HAZARDOUS VOLTAGE 1

Inhaltsverzeichnis

Seite 1 - HAZARDOUS VOLTAGE

ON ON1 2 ACTLNKAPPLCOMMSD1D2D3D4D5R9R8R22R21R20watchDOG Card Installation1. Turn off the PV system by setting the AC/DC switch to the off pos

Seite 2

The watchDOG has 5 LEDs and one reset button. When looking down onto the watchDOG card, the LEDs are placed in the following order from back to fro

Kommentare zu diesen Handbüchern

Keine Kommentare

Kaco watchDOG Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Fotozubehör Kaco watchDOG herunter. KACO watchDOG User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fotozubehör Kaco watchDOG